According to INPIA, this morning, the 35th meeting of the Education Commission of the National Association of Plastic Industries of Iran was held at the Polymer and Petrochemical Research Institute of Iran. At the beginning of the meeting, the Secretary of the National Association presented a report on the performance of the Education Commission in […]
According to INPIA, this morning, the 35th meeting of the Education Commission of the National Association of Plastic Industries of Iran was held at the Polymer and Petrochemical Research Institute of Iran. At the beginning of the meeting, the Secretary of the National Association presented a report on the performance of the Education Commission in recent months, according to which, six training courses have been held by the Education Commission of the National Association. Then, Mr. Turk, Chairman of the Education Commission of the Association, presented a report on the situation of the air molding working group to the members of the meeting and explained the training courses in this field. In this regard, this member of the board of directors of the association said: wind molding is a field on which no private work has been done and it seems that it is necessary to hold these training courses for the country’s craftsmen. The next agenda discussed was the decision on when to hold the UPVC window profile training course, which was scheduled to take place in November. Then Ms. Rafiei-Tabar explained about the new website launched by the Education Commission of the National Association and showed the audience the facilities of this “National Plastic Industry Training Network”. Then the Turkish engineer explained about the goals and fields of establishing this website and said: this site has not been officially announced yet, but we will unveil it in the near future. The final discussion of the meeting was the holding of the annual conference of the association on the subject of “economic” analysis of plastics industry. The main idea of this plan is for the plastics industry of the country to know the analysis of economists and experts in the plastics industry for their annual planning through this conference, and to enter the new year with more knowledge about the industry and follow their plans. “This conference can give very important data and clues to the industrial situation of the country to the industrialists and remind them of many considerations, and I believe this conference can be an effective step in the growth of the production units of the plastics industry,” said Turk. In the end, it was decided that during the next meeting, the faculty and the executive board of this conference will be determined to make a well-written plan for holding this conference as well as possible.
This article is untagged.